Support Center

Portable Power Packs

Last Updated: Dec 17, 2013 04:18PM PST
5400

Portable Power 5400


PDF: English / Español / Français / Deutsch / 日本語 / 한국어 / 繁体 / 繁體

Product Information
  • 5400mAh battery for 2 full iPhone charges
  • Built-in USB cable for charge input
  • USB-A port for connecting your own iPhone charge cable
  • 5-stage LED charge indication
  • Non-slip rubberized bottom
  • Output: 5V, 0.5~2.1A / Input: 5V, 0.5~1A
  • Compatible with all iPad, iPhone, and iPod touch models and most USB chargeable devices requiring a 5V input from 500mA to 2.1A when used with the appropriate device cable. Note: Devices with a mAh capacity larger than 5400mAh can be charged, but may not reach 100% depending on their starting charge level.

Charging your Portable Power
  1. Connect the built-in USB connector to a power source. You can use the USB wall adapter that came with your iPhone or an available USB port on your computer.
  2. One of the 5 LEDs will blink to show that the battery is charging. Each LED will turn solid until all 5 are lit and the battery is full.
  3. To stop charging, disconnect the USB cable from the power source.

Tip: Charging time will depend on the battery's current level and the output of the power source, but you can expect a full charge in about 6 hours from a 1A wall charger. Using a computer's 500mA USB port will take about twice as long.

Using Portable Power to Charge your devices
  1. Provide your own device cable and connect it to your device and to the USB port on Portable Power.
  2. Your device should now indicate that it is charging.
  3. To check the battery status, press the function button and the LEDs will light from 0-5 depending on the remaining charge in the battery.
  4. To turn off, disconnect the device cable.

Tip: Charging time will depend on your device's current level and its activities while charging. Please refer to your device's manual for relevant charge times and note that using your device or active apps while charging can slow the charging process.

Good to know
  1. Portable Power is designed to only charge itself when connected to power. Make sure to keep it topped off and ready for use.
  2. It is normal for Portable Power and your device to be warm during charge cycles.
  3. Recharge every few months when not in use.
  4. Avoid liquids, moist environments and corrosive materials.

Safety, Regulatory and Legal Notices Limited Warranty and Exclusions
This product has a warranty against defects in materials and workmanship under normal consumer use for a period of one year. Only batteries whose fully charged capacity falls below 80% or batteries that leak are covered by this limited warranty. Any evidence of abuse or misuse as defined in the warnings section will exclude coverage.

Warnings
Please read all instructions and warnings prior to using this product. Using this product in ways other than intended could result in product damage, toxic fumes or explosion for which manufacturer is not responsible.
  1. Do not expose battery to heat sources, extended direct sunlight or other high temperature environments.
  2. Avoid drops and excessive impacts to the battery.
  3. Do not disassemble, attempt to repair or replace any part of the housing or battery.
  4. Do not attempt to charge by any method other than described in the instructions.
  5. Follow state and federal environmental laws and regulations by taking to a local battery-recycling center when no longer using this product.

FCC Notice to Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment under FCC rules.

Industry Canada Notice to Users
This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference, including interference that may cause undesired operation of the device. See RSS-GEN 7.1.5. This class B digital apparatus complies with Canadian ICES-003.

Customer Service
+1-888-283-8288

Legal
Manufacturer shall not in any way be liable to you or a third party for any damages suffered by you or a third party as a result of intended or unintended use or misuse of this battery in conjunction with a mobile device or accessory other than those for which it was designed. If damages result from battery use with an unintended device and you are responsible for that use, you agree to indemnify Manufacturer for any resulting damages and injuries to yourself or a third party.

iPhone, iPod and iPod touch are trademarks of Apple, Inc., registered in the U.S. and other countries. iPad is a trademark of Apple, Inc.



2500

Portable Power 2500


PDF: English / Español / Français / Deutsch / 日本語 / 한국어 / 繁体 / 繁體

Product Information
  • 2500mAh battery for 1 full iPhone charge
  • Built-in USB cable for charge input
  • USB-A port for connecting your own iPhone charge cable
  • 3-stage LED charge indication
  • Non-slip rubberized bottom
  • Output: 5V, 0.5~2.1A / Input: 5V, 0.5~1A
  • Compatible with all iPad, iPhone, and iPod touch models and most USB chargeable devices requiring a 5V input from 500mA to 2.1A when used with the appropriate device cable. Note: Devices with a mAh capacity larger than 2500mAh can be charged, but may not reach 100% depending on their starting charge level.

Charging your Portable Power
  1. Connect the built-in USB connector to a power source. You can use the USB wall adapter that came with your iPhone or an available USB port on your computer.
  2. One of the 3 LEDs will blink to show that the battery is charging. Each LED will turn solid until all 3 are lit and the battery is full.
  3. To stop charging, disconnect the USB cable from the power source.

Tip: Charging time will depend on the battery's current level and the output of the power source, but you can expect a full charge in about 3 hours from a 1A wall charger. Using a computer's 500mA USB port will take about twice as long.

Using Portable Power to Charge your devices
  1. Provide your own device cable and connect it to your device and to the USB port on Portable Power.
  2. Your device should now indicate that it is charging.
  3. To check the battery status, press the function button and the LEDs will light from 0-3 depending on the remaining charge in the battery.
  4. To turn off, disconnect the device cable.

Tip: Charging time will depend on your device's current level and its activities while charging. Please refer to your device's manual for relevant charge times and note that using your device or active apps while charging can slow the charging process.

Good to know
  1. Portable Power is designed to only charge itself when connected to power. Make sure to keep it topped off and ready for use.
  2. It is normal for Portable Power and your device to be warm during charge cycles.
  3. Recharge every few months when not in use.
  4. Avoid liquids, moist environments and corrosive materials.

Safety, Regulatory and Legal Notices Limited Warranty and Exclusions
This product has a warranty against defects in materials and workmanship under normal consumer use for a period of one year. Only batteries whose fully charged capacity falls below 80% or batteries that leak are covered by this limited warranty. Any evidence of abuse or misuse as defined in the warnings section will exclude coverage.

Warnings
Please read all instructions and warnings prior to using this product. Using this product in ways other than intended could result in product damage, toxic fumes or explosion for which manufacturer is not responsible.
  1. Do not expose battery to heat sources, extended direct sunlight or other high temperature environments.
  2. Avoid drops and excessive impacts to the battery.
  3. Do not disassemble, attempt to repair or replace any part of the housing or battery.
  4. Do not attempt to charge by any method other than described in the instructions.
  5. Follow state and federal environmental laws and regulations by taking to a local battery-recycling center when no longer using this product.

FCC Notice to Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment under FCC rules.

Industry Canada Notice to Users
This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference, including interference that may cause undesired operation of the device. See RSS-GEN 7.1.5. This class B digital apparatus complies with Canadian ICES-003.

Customer Service
+1-888-283-8288

Legal
Manufacturer shall not in any way be liable to you or a third party for any damages suffered by you or a third party as a result of intended or unintended use or misuse of this battery in conjunction with a mobile device or accessory other than those for which it was designed. If damages result from battery use with an unintended device and you are responsible for that use, you agree to indemnify Manufacturer for any resulting damages and injuries to yourself or a third party.

iPhone, iPod and iPod touch are trademarks of Apple, Inc., registered in the U.S. and other countries. iPad is a trademark of Apple, Inc.

Contact Us

support@goincase.com
http://assets1.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete